Layout Work Resumes - Wetherbee's Hardware (Part 1)

With the book in hand and shipping (thanks to everyone who ordered the book!) it's time to turn my attention back to the layout, and to this blog!

You ever get completely overwhelmed by the number of projects you want to complete? My typical reaction when that happens is to start a bunch of stuff that I'll work on for a bit, then put away. OR I just get some sort of overload and can't start or finish ANYTHING! The latter is what happed to me about three weeks ago.  I went downstairs, turned on the layout room lights, looked around, and promptly turned them back off! There seemed like there was so much to do I couldn't come up with a single project to focus on. 

Of course, thinking about this logically I'd remember that no matter how many projects I might want to do, I can only do one thing at a time!

There are too many empty lots in what is supposed be Enosburg Falls - and ideally, I'd like to get the rest of the structures for the town completed in time for the Mid Atlantic RPM meet this fall. I don't know if we'll have an open house this year as part of MARPM, but getting the town looking "done" by mid to late fall seems a reasonable goal. 

Between the CV freight house and the front edge of the layout is a large open area - approximately 7"x18" defined by Archambault Street and Railroad Ave. This is across the street from the implement dealer that I built five or six years ago. I did a nine or ten part series of posts on that build - you can find part 1 HERE.

As I was flipping through the History of Enosburg Falls book I came across this photo of a hardware dealer that, according to the descripition in the caption,

Test fitting walls and windows. Nothing is glued up or square at this point!

Experimenting with different finishes on piece of scrap shingles. 

Shot of the left front facade shows the two different types of siding. 

was located near where I had that blank lot. It was a fairly long, narrow building and I thought while it's in no danger of winning any architectural awards, it was typical enough of the business district of a New England small town that it would make a nice addition to the scene. 

I don't know for certain, but it looks as if this was two older buildings - perhaps a house and a barn? - connected with a "modern" addition connecting them together. Note this is the only picture I have found of this building, so I would have to imagineer the rear and side walls!

The first step was to figure out how to build this thing. My go-to and much preferred material is styrene, but in this case the entire street facing upper floor of the building is shingled. Note these are not shakes - these shingles have flush cut ends with varying widths. I've built a number of BEST Trains laser structure kits and several of them use laser etched wood sheets with the shingle pattern embossed in the wood. Thinking that would be easier than applying individual layers of shingles, I ordered a sheet of the stuff. For the first floor of the street side of the building I opted to use .090" vertical scribed boards. 

I dug through my rather extensive collection of Tichy and Grandt Line door and window castings and came up with close enough matches to what showed in the protoype photo. I did have to shorten the middle section somewhat - meaning I don't have quite as many big shop windows as the prototype - but I doubt anyone will ever realize that unless I tell them!

I will say it's been a long time since I cut window openings out of wood stock - and it's not something I enjoy. At this point I have front walls cut out - and my original plan was to use wood for the entire building, especially for the side wall that looks fairly weathered and worn from the little bit of it that shows in the right edge of the photo. But I'm toying with making the remainder of the building out of styrene.