Pages

Thursday, February 1, 2024

A New Addition to the Layout - Part VI: Basic Background Scenery

Test fitting the background scenery foam panel. I think the road "extension" blends fairly well. 


I haven't touched the northern SNE branch section for almost a month or more since I've been focusing on background scenery on the mainline "loop" around the room. But I'd made a bunch more trees, and I was getting sick of tripping over the two chunks of the mountain that we'd recovered from the helix move disaster - but the mountain chunks were useable even if looking a little dusty and faded. 
We'd built a box framework section to fill the space between the main layout and the branch. I took two of the mountain sections and test fit them in place as seen here:
Obviously there's a need to fill the gap between the "chunks" of mountain! The roof of Charleton station is to the left. I grabbed a quick test shot from the "normal" viewing height looking over Martin Machine as well. 

Mostly to avoid working over the finished portions of the branch I cut a piece of foam board to fit the space between the wall and the finished portion of the branch. I added a couple of small hills to break up the pool table look and added two roads after marking where they connected into the existing roads on the branch section. One road runs straight across the addition (lead photo above) while the road by the station curves and goes up a slight hill. I'll show how these blend into the wall in a future post. I test-fitted the piece (below) before adding the initial scenic texturing in the workshop.  
























No comments:

Post a Comment