Pages

Thursday, October 24, 2013

Building Waterbury 2: Feed Mill - Walls and window openings

This view shows the street side wall of the building and the addition that was on the rear of the structure.
Since the model was originally built for a narrow shelf layout I never bothered adding clapboard to the wall away from the tracks. In fact, this was all that was visible, so it's all I modeled. This time the building can be viewed (from a distance) from the other side of the peninsula so I needed to add clapboards and the rest of the addition to this side.
 
At this point I've added the new walls to the street side of the building. The angled wall was originally used to accommodate a siding that once wrapped around this side of the building. By my era the track was no longer in use. NOTE: For this photo the building has been moved from it's planned location on the layout.

 Since this building was started well before I began this blog, I don't have photos of the earliest stages of construction. Basically, I built an inner shell of plain styrene (usually .030" or .040"). After locating the window and door openings, I used the well known scribe and snap method to create the window and door openings. After the sub walls were reassembled, I applied the outer layer of Evergreen .040" scribed clapboard siding. Once that's dried, I cut the window and door openings in the clapboard from the back (using the openings in the subwall as a guide).

Next steps on this building....foundation and roofs.....









No comments:

Post a Comment