Mill stream progress and filling gaps

As mentioned in my previous blog post I needed to fill the gap in the surface of the mill stream. Turns out a piece of Gatorboard that I had lying around was the right overall size - some quick work with a hobby knife trimmed it to fit the oddball shape of the opening. This was secured in place with a healthy bead of hot glue. One side of the building has a door and windows on the lower floor so I needed to have some open ground on that side of the structure. I cut more Gatorboard and added some Chooch cut stone material. The photo shows it being rough fit in place. 

Next, I cut a thin piece of foamboard to raise the mill building slightly above the water surface. Actually, it made the bottom of the building just about even with the "water" level. 

When I added the fascia the "Upper Road" (former roadbed on the Northern SNE) ended up with a gaping hole between the fascia and the plywood subroadbed. I trimmed several pieces of pink foamboard and used them to fill the gap.